Parts by type
Plastic machine parts: what each is usually made from, and how.
Start from the part, not the catalog. Each row names the plastic that kind of part is usually made from, why, and which process cuts it. This is a guide to what suits the part. It is not a list of jobs or customers; those are never published here.
| Part | Usual material | Why | How it is cut | Price |
|---|---|---|---|---|
| Wear strips and guide rails | UHMW | Slippery and very hard to wear out. Cheap enough to replace. | Routed from sheet | Price one → |
| Guides and lane dividers with a bore or a fit | Acetal (Delrin) | Holds size where UHMW will not, and still slides. | Routed or milled | Price one → |
| Bushings and sleeves | Acetal, nylon, PTFE | Acetal for a fit that has to stay put, oil-filled nylon to run dry, PTFE for chemicals. | Machined from rod | Price one → |
| Rollers and wheels | Nylon, acetal, UHMW | Nylon carries load and takes a hit. Acetal if it runs wet. | Machined from rod | Price one → |
| Spacers, standoffs and insulators | Acetal, nylon, G-10, phenolic | G-10 and phenolic when it has to be stiff and must not conduct. | Milled, or routed if flat | Price one → |
| Trays, nests and panels | HDPE | Cheap, tough, shrugs off most chemicals. Pockets cut in the same setup as the outline. | Routed from sheet | Price one → |
| Machine guards and windows | Polycarbonate, acrylic | Polycarbonate will not shatter. Acrylic is clearer and scratches less, but it is brittle. | Routed from sheet | Price one → |
| Manifolds and housings | Acetal, PVC, polypropylene, polycarbonate | PVC and polypropylene for chemical service. Polycarbonate when you need to see in. | Milled from block | Price one → |
| Seals, seats and slide pads | PTFE, PEEK | PTFE for chemicals and low friction. PEEK when it is hot or loaded. | Milled | Price one → |
| Fixtures, jigs and soft jaws | Printed PETG or nylon; acetal | Print it if it only has to locate a part. Machine it from acetal if it gets clamped on all day. | 3D printed or milled | Price one → |
Dimension matters, or wear matters?
Pick acetal when a dimension has to hold. Pick UHMW when the part has to last against something rubbing on it. Few plastics do both well.
Hot, wet or washed down?
Say so. Nylon grows when it is wet, polyethylene grows when it is warm, and some cleaners crack polycarbonate. The right material fixes what a tighter tolerance cannot.
Touches food?
Compliance belongs to a maker's grade, not to a plastic. What a machine shop can and cannot certify.