Plastics machine shop · Wauconda, Illinois847-260-8104
CNC routing, sheet and plate

Flat plastic parts cut from sheet, with pockets and counterbores.

If your part is flat, cutting it from sheet on the router is usually the cheapest way to make it. Outline, pockets, holes and counterbores come off in one setup. Sheet from 1/16" to 1" thick is priced online.

The button opens the quote tool on routing. Drop in a STEP file, or a DXF of the outline and pick the thickness, and the check tells you how many of your part fit on a sheet. Not sure it is a router part? 847-260-8104 rings the shop.

White plastic tray with a machined pocket and slots, lying on a router table

What belongs on a router

  • Trays, nests and panels in HDPE.
  • Guides, rails, lane dividers and wear strips in UHMW and acetal.
  • Machine guards, windows and covers in polycarbonate and acrylic.
  • Spacers, templates and fixture plates in PVC, polypropylene, G-10 and phenolic.

Machine and limits

  • The quote tool takes flat parts up to 59" × 96" and 1" thick. Over 1" thick it is a milling job.
  • The check nests your part on a 48" × 96" sheet and tells you how many fit.
  • Profile tolerance ±0.010" (±0.25 mm). Large HDPE and UHMW parts move with temperature, so say what the part runs at.
  • Inside corners carry the cutter radius: 1/32" in sheet up to 3/16" thick, 1/16" up to 1/2", 1/8" up to 1".

Design notes that save you money

  • Keep the web between cutouts at least half the sheet thickness, and never under 0.060". Thinner ones flex into the cutter and tear.
  • A hole cannot be smaller than the cutter. Keep holes one diameter in from an edge.
  • The check flags parts under about 1.5" across: they are tabbed into the sheet and trimmed by hand. Expect a small witness mark on one edge, and say which face matters.
  • Engraved text needs strokes of 1/32" or wider. 1/16" cuts clean.
  • Quantities that fill whole sheets price best.

What a router does that flat cutting does not

A laser or a waterjet cuts straight through the sheet. A router cuts to a depth, and that is the difference between a flat blank and a finished part.

  • Pockets and steps that go partway through the sheet.
  • Counterbores and recesses, so a fastener head sits below the surface.
  • Thick stock. The quote tool prices sheet and plate up to 1" thick.
  • Engraved part numbers and text.
  • If your part is only an outline and through holes in thin sheet, you do not need any of this.

Materials priced online

Full material guide →
HDPEUHMWAcetal / DelrinNylonPolycarbonateAcrylic (cast)PVC & expanded PVCPolypropyleneG-10 / FR-4Phenolic6061 plate
White notched plastic disc held over the sheet it was cut from
Two stacks of white notched plastic discs beside the sheet they were cut from
White plastic plate with a pattern of drilled holes