3D printing, FDM and SLA
Print the prototype. Machine the part.
Printing is how you get a fit check in your hands before any plastic is cut, a fixture to hold the production part, or ten of something that does not justify a program.

What printing is for
- Fit and form prototypes before cutting plastic or aluminum. Print it, hold it, change it.
- Jigs, fixtures, soft jaws, drill guides and go/no-go gages.
- A fit check for a replacement part, tried on the machine before the real material is cut.
- Low-volume end-use parts in PETG, ABS, nylon and TPU, where printed is good enough.
- Fine-detail parts in SLA resin: small housings, snap fits, cosmetic models.
- A resin picked for the job: Tough 1500 or Tough 2000 for a part that flexes or takes a knock, Rigid 10K for stiffness, ESD for electronics work, Clear when you need to see through it.
Machines and limits
- SLA: Formlabs Form 4 and Form 3.
- FDM layer heights of 0.1, 0.2 and 0.3 mm, chosen in the quote tool.
- SLA resins: Formlabs Grey, White, Clear, Tough 1500, Tough 2000, Rigid 10K, High Temp and ESD. Layers of 0.1 mm or 0.05 mm.
- The build-volume check in the quote tool tells you whether the part fits before you pay.
When not to print
- If it needs a real bearing surface or a press fit, or will see 150 °F in service, it wants to be machined from acetal or nylon.
- Over about 50 pieces of a simple flat part, routing from sheet is usually cheaper and the parts are stronger.
- A printed part is weakest between layers. If the load pulls the layers apart, machine it.
Materials priced online
Full material guide →PLAPETGABSNylon (PA12)Carbon fiber nylonTPUGrey resinWhite resinClear resinTough 1500 resinTough 2000 resinRigid 10K resinHigh Temp resinESD resin


